Ventilation requirements
⸺
Monolith appliances are ventilated entirely via the plinth panel.
The door panels must close at least 102 mm above
the floor. The grill in the plinth panel must not be
obstructed.
In the scope of supply of the Monolith appliances, spacers are
included which must be fitted to the appliance and to the door
in order to separate the warm outgoing air from the fresh air
flowing in.
Liebherr provides a 102 mm high plinth panel made of stainless
steel as an optional accessory. This is available in the relevant
Width of the Monolith model and possible Side-by-Side combinations
60 (from 45.7 cm to 182.8 cm).
The plinth panel, the position depth of which can be varied, is
assembled by means of an adhesive joint (pre-assembled on the
appliance).
See “Optional accessories” on page 54.